Cub style square ottoman with storage is an attractive way to create additional seats for customers and to hide storage. These ottomans can be made to any size you need and covered with any skin color. Wheels are mounted at the bottom and seat storage ottoman can be easily moved around the room to serve as a stool, seat or open storage container. When finished footstool can be used as a coffee table or slipped under a table until needed again.
Apply a bead of construction adhesive along the left edge of the board 1. Press the glue to the right of the board 2 so that the edges are even. Nail through the outer panel 2 on the end of the board 1. You must have a form of “L”. Applying adhesive along the left edge of the plate 2. Press the glue on the right side of the plate 3 so that the edges are even. Nail through the outside of the gasket 3 on the end of the board 2. You must have a “U”. Apply adhesive to the left end of the plate 3 and the right end of the dashboard 1. Press 4 on the glue on both sides. Align the corners and hail through the outside of the plate 4 in the ends of boards 1 and 3. You should have a square ottoman with storage.
adhesive to the top of the spray cap. Paste 3-inch thick foam from the top of the lid and seat with an electric knife. Court hitting 24 square inches. Place the side of the foam from the top down focused on hitting. Pull the bat to the bottom of the cover and staple every 2 inches. Cut a 24-inch square of 4-5 ounces (or less) of leather. Place the leather down. Place the foam from the top down and centered. Staple the skin on the bottom. Staple the center of each side first and work towards the corner. Fold and tuck the corner for a fresh look. Trim the excess skin. Cut Leather 16 inches by 50 inches. Place the right square ottoman with storage and sew a seam right half-inch along the short ends. Turn the right side of the leather and slide on the hub so that equal amounts of leather can be folded and stapled on the inside and on the bottom.